Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Re: Command RN42 Bluetooth module
Hi all,
I am actually trying to connect a BT connexion among the RN42-I/RM:Module BT Class 2 module, to another different BT modules (HC06,Mistumi). However, to pair them is being unsuccesful because of the RN42 firmware version v.15. So, I should upgrade the...
Hi all,
First at all, I apoligise since I was focus in other tasks, so that I could´t reply you as soon as I expected.
I have got some results from a Pmos transistor configuration as a switch.
As reminder, I want to clarifiy that the purpose of the circuit is to switch the Mosfet on/off...
Thank you very much for your useful clarifications. I´m actually checking the behaviour with higher Rds Mosfet values. I will let you know the results as soon as I get it done.
Command RN42 Bluetooth module
Hi,
I have just connected the RN42 BT module as a Master with HC06 BT module (as a slave), everything works properly so far. The command I am using in order to pair both BT modules is ( C,<address> ), however, now I would like to go a step further connecting them...
Hi all,
I´m actually checking the Bluetooth connectivity among the RN42 BT card (as a Master) and HC06 card (as a slave). I´m using Coolterm platform in order to register the RN42 commands to manage the connectivity. It seems everything is working properly using different commands, until I...
Hi Klaus,
First at all, Thank you for your feedback.
Alright. The purpose is to design a Mosfet as a switch, such as the following link below;
**broken link removed**
An Inertial Unit (accelerometer) will be connected into the Vout pin. This switch will be controlled by a Microcontroller...
Hi There,
I hope everything is going well
I´m quite focus on adding a Mosfet as a switch, in order to block/allow the voltaje to the load.
However I´m currently getting a trouble, which is the current leakage as long as I´m blocking the switch.
I have enclosed you a shot, so as to show you...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
