Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Hi,
I was design a maxwell3d transient project with 2 coil a transmitter and a receiver.
Transmitter fix and transmit signal and receiver have a motion and receive signal.
transmitter is a coil with winding with sin current excision and 2000turn
receiver is a coil with winding without excision...
Hi every body,
This is a opamp output voltage booster schematic but I can not understand how each part work ,if any one can analysis this circuit please explain it for me in detail.
Hi mdyusuf,
your answer is for interior of my system but my problem is for out of my system and when connect it to many systems together in one larger unit such as vehicle. single point connection do not applicable because I have many connection (for example 5) to other systems and I do not know...
A) You see 16 question mark near parts in this design please tell your idea about them:
A1) each parts (res or cap) should or should not be used?
A2) value of each part is ok?
A3) Nets at both side of each part is ok?
A4) How many of each part must be used?
B) This section use for isolating...
Hi every body,
when I want to design a system with 28v power input, I have an earth and a 28v return so in many document I can read these must be isolated but in automotive ,vehicle and airplane skeleton and structure is connect to 28v return (I have not a wire for 28v return) so I must connect...
when connect rgsb signal to a standard monitor (with green and gnd signal) when a noise occur monitor display go off and on again (TFT Controller start automatic detection of signal again) but when connect to my display (It is a fix resolution Display) it is have a line in display (Horizontal)...
Thank you for your attention
It is RGsB and I made it through FPGA and ADV7125 and filtered with ADA4412 also it has common mode chock and ferrite on video and return line.my connector is triaxial and inner shield of cable connect to video return (it is not isolated from circuit GND but circuit...
Hi
I have two video in my system one of them is PAL and other is RGsB (VGA 800*600 60Hz but CSync composite on Green[SOG])
When we have a noise around my system, PAL output has a good video quality but RGsB output does not has a good video quality and video on display is not stable.
What is...
Hi
I want to drive an inductive load ( 600uH) with -1.5A to +1.5A. Input signal is an unformed signal -10v to +10v (every form and non periodic ).
I do that with an opamp and a pushpull and current feedback of inductor ( a resistor series with inductor so voltage of it equal to current of yoke...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.