Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Is there any way to hook up this 21" display with USB cable and be able to adjust the V-size H-size etc... On XP? I searched and came up short. If it is possible could someone hook me up with the specific software/driver to do this? And telling me to make a bootcamp / XOM cd or install XP with a...
hi,
generally its an industry level code.
but sometimes it may have codes for chipsets.
your code indicates intel 815 chipsets.
modern mother boards always has the chipset code in its serial code.
TeE ThE EdE
hi,
tracks must be green masked ,only pads are left for soldering reason.
from eagle command toolbar choose the display button select everything but leave pads and vias if u've them in your design, then click change then ok.
now you have the pads pattern.
what you gonna do now is what you did...
hi,
HDDs have their own microcontroller already built in it.
processor has no relation with HDD capacity.
for instance when a DMA transaction happens the HDD µc deals directly with main memory leaving the processor for other operations.(The interleaving technique)
BY the way processor also don't...
uhaaa , got you
after finishing your board ,from file menu choose export then image
select a name and check the monochrome check box then save it.
then open the image with windows paint and from image menu choose invert colors.
Voila , your image is ready:D
TeE ThE EdE
hi there,
i'll assume that you know how to deal with schematics and layouts , so you better try Eagle from CadSoft.
here is a link to a useful page describing how to use eagle.
**broken link removed**
when you finished with eagle just tell me to proceed to the next.
waiting.............:D
TeE...
hi,
when you push the print button , the print menu pop out.
there you can see a check box called Mirror ( the first check box).
by printing your work mirrored ,the output image will be inverted.
but why do you want to invert it , while eagle prints images normally.
bottom side & top side is...
coool :D,
so, do u've any good way to apply it to the board with a good finish look.
is this protective mask must be treated like this coz i bought it in a small expensive very thick quantity.
thx anyway
TeE ThE EdE
hi,
well i just had a green pcb protective coating, but when i tried to apply it i had a problem that its a thick coating .
i can't get a thin layer over the board so it goes darker.
i need to get a thin soft layer of it.
any ideas?
hint: i'm not talking about solder mask:!:
TeE ThE EdE
mos breakdown voltage measure
hi,
breakdown voltages will be found in datasheets,selection guides and data books.
i recommend you the ECA books or CD roms.
TeE ThE EdE
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
