Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Hi everyone,
In a buck converter, for example 100 V DC has to be decreased to 50 V DC. But here, after design of buck converter we will see average value of output at output side. But we will not see average value of input at input side. That means, the 100V DC has to be reduced to 50V DC but...
Thank you for your response. I didn't understand your point. Can you please, verify what you are saying with MATLAB? Please, send the MATLAB simulation code or simulation steps for this.
Hi Friends..
We are doing the project on "Biological Tissue model based on Fractional Capacitor". For that, we are using MATLAB simulation. We took the reference paper : "A Survey of Fractional-Order Circuit Models for Biology and Biomedicine, Todd J. Freeborn". For that, we need the procedure...
Hi Friends...
I've some doubt regarding the requirements of input impedance and output impedance of any device/circuit. We all know that one of the advantage of MOSFET over FET is:
1. "The input impedance of MOSFET is high compared to FET and output impedance of MOSFET is less compared to...
Thank you sir. Can't we calculate %THD directly without any calculations (like FFT of Vout spikes, V1, V2..) in OrCad.? If not, please clarify how to calculate these FFT of Vout in MATLAB, V1, V2, ..... Sir, please attach any PDF or LINK which has the step by step procedure to do the %THD in...
Hi Friends..
We are designing filter in OrCad. For that, we need THD calculation. Please, suggest how to measure total harmonic distortion in OrCad tool. Thanks in advance.
Thanks for your response Klaus. But, what information is needed for this.? Why can't we measure the water level using FPGA.? Can't we use any sensor.? If not, why.?
Hi Friends..,
We are doing the mini project WATER LEVEL INDICATOR/CONTROLLER using FPGA. Please, suggest me how to proceed to do project. I don't know FPGA basics also. Please, give me a clear information. Thanks a lot in advance.
Hi friends,
I have a few general doubts about MOSFETs.
1)Is it need to maintain same size and same doping for both source and drain.? If, why.?
2)What is the need of SiO2 for only gate and why not for source, drain.?
3)Why do we choose CMOS when MOSFET(NMOS) is present.?
Please, kindly...
Fine my dear friend.. Here, I'm applying the voltage from RPS. Even, u r saying the current produced by voltage sources are changing.. Is it possible in this circuit..? That is, if i1= 0A then i2=1A, but how it change immediately..? I knew, the current flowing through resistor is 1A, but i...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
