Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Hi
Thanks for your reply!
Could you please share any module(eg SIM900) Multiplex mode code to work with GSM/GPRS so that it will use AT command and can detect when connection goes down.
Looking for your help!
Thanks
Hi FvM
Thanks for your reply!
In my project i don't need to use Multiplex mode. As i need only one socket CID to configure and use it only.
Even in multiplex i need to suspend the one socket and check for other.
Considering my constrain of project please help me out with the issue.
Let me...
hi
I had same issue.
Remember to put AT&K=0 at starting of program and don't invoke home page.
You can try with below URL and it will definitely work :)
//Check registration status
AT+CREG?
//Get the configuration of the sockets
AT&K=0
AT#SCFG?
//Check if any socket has been activated...
Hi
I am using Telit module.
Once i do socket configuration and start the socket connection using AT#SGACT and AT#SD command i start posting data to server in while loop using post.
My question is how can i check the connection status eg still connected or not so that i can continue sending...
Hi AKENAFAB
Thanks for your quick response.
I don't need GPS in my module.
I just need high quality and reliable wireless internet connection.
Please suggest me which one i should prefer SIM900 or Quectel M95.
Thanks in advance.
Hi
I am trying to make a product which need GPRS(Internet connectivity).
Could you please suggest me which GSM/GPRS module is best for practical use.
It's not project.It's for product.
I need to use low power consumption and fair cost.(need not to be very low)
For test i am using SIM900...
Hi
I solder SIM900 with PCB and now i am trying to test the connection with breadboard. I am able to switch on the netlight after pushdown the pwr_key button.
But it's frequency of blink never come down.(it is not able to find network)
I think there is some issue in connection of SIM_HOLDER...
I am trying to test the SIM900 with the given schematic.(Openelectronics schematic) on breadboard.
My netlight is working but it never find the network.(SIM_VDD no voltage).
My question is :will breadboard connection can work or not.
Waiting for your reply.
Please
let me know do i need to...
- - - Updated - - -
Hi I am new to electronics.
I am not getting voltage on sim_vdd.
Could you please help me with that.
Could you please share you schematic with us.Or can you please mail the schematic to somnath678@gmail.com.
Thanks in advance.
Attaching the my schematic.
Hi I am new to electronics.
I am not getting voltage at SIM_VDD pin of SIM900.I followed schematic of SIM900 datasheet.
Could any one please help me with that.
Could you please share you schematic with us.Or can you please mail the schematic to somnath678@gmail.com.
Thanks in advance.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.