Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Hi all,
I am looking for device to interface 4 wired Pt100 on side and and I2C output on the other side (only one I2C o/p is enough). Our limitations are with smaller footprint. We have 3.3V,5V and 12V power supplies to power the device.
Currently I am working with the universal transducer...
Hi all,
I am working with LPC2468 board from embeddedartists using the IAR Embedded Workbench 7.3
I want to write my results read from a double variable into a txt file created on the PC. I read on the forums and already set the library settings to FULL to read the Dlib_Config files...
Hi.
I am not able to understand the functionality of some PWM registers to be used in capture mode.
I have been trying to interface the PWM based max6672 sensor with the PWM capture pin. I want to read the both the low time and high time of the PWM pulse. I am recieving an interrupt when the...
Hi,
I am using IAR Workbench with Embedded Artists LPC2468 development board. I am trying to read the status of pressure sensor via I2C. In the code the state of I2CSTAT is not changing and interrupt is not being generated.
I am using I2C0. Can someone point out the mistake?
The main code...
Hi,
Indeed it is difficult to get job in big companies who work in electronics. But companies like Wipro and Infosys also have a division which works in electronics system design. You can also try in KPIT Cumins.
Regards
Well you can use a python script to read the data from an oscilloscope directly and write it to a .dat file. You will not need any controller for that. You can also set the triggers from the scripts.
Hi all,
I going to use a SOCKET, SMA, RIGHT ANGLE, 50OHM in my PCB link here https://uk.farnell.com/te-connectivity-amp/5-1814400-1/socket-sma-right-angle-50ohm/dp/1248989
I was able to find the smb_90.dra and smb_90.psm files in the Allegro Starter / Evaluation Library...
When you synthesize a code you are actually going to put it in hardware and it generates fitter settings,but simulation is only for conformation of code with respect to time instance.for example some statements such as (wait for 1 ns, after 20 ns) is not
synthesizable because in HW one cannot...
Use case statement with if else.Case statement to determine the FSM states and if else to switch between states.Any VHDL book can guide you.I recommend VHDL by Ashendan(not sure of spelling)
HI,
I am trying to interface DVI input output with Altera Cyclone 3 board.I have to set parameters in the DVI component window for
horizontal sync
horizontal front porch
horizontal back porch
vertical sync
vertical front porch
vertical back porch
Can some one help me with these settings...
Hi,
I using the Altera cyclone III EPC3C120 Development board connected by HSMC interfaces to Bitec HSMC quad video and DVI daughtercards.
The kit refers to AN 427 VIP sample design and asks it to download from the ALTERA site.
The name of the file is vip_example_design_3c120_<version>.But I...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
