Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Yes, absolutely! One important thing to remember is that for this to work you must have one end acts as CPE (client - which is the end customer unit that you're using now) and another end acts as CO (Central Office - which the service provider uses). The ADSL/2/2+ splits the entire 2+ MHz...
Re: ATM Switch with FPGA
First you need to have a fundamental ATM technology, network switch technology, queuing/scheduling algorithms, and some basic system knowledges to tie all these pieces together.
The fundamental of ATM is that it operating quanta is 53 bytes cell where the first 5...
project graduation voip
Are you trying to convert from IP to ATM network? U need to describe the scope of your project more clearly - VoIP to mobile connection? It may be too broad for a graduation project.
Cheers,
-s
I am assuming you're referring to Ethernet MAC. If this is so, then follow the link here for the RTL code and spec on the 10/100 Ethernet MAC implementation: **broken link removed**.
Hope this helps,
-s
vhdl fir filter
Decimating by a factor of 2, simply, means you only have to take half the input samples. It's up to you to take either even/odd only samples.
Cheers,
-s
Re: gpon
GPON=Gigabit Passive Optical Networks. This is a newer generation of the PON based networks standard which is capable of up to 2.4Gbps/2.4Gbps in upstream and downstream direction. Checkout the book by Cedric Lam "Passsive Optical Networks - Principles and Practice".
Cheers,
-s
Re: verilog to schematic
You can use Synplicity tool (Synplify/pro) as an RTL sythesis engine and/or RTL viewer in structural and gate level schematic. Agreed with FvM that you'd better off learning the in and out of the RTL language iso the schematic version.
Cheers,
-s
Re: band pass filter
First let start with the fundamental, i.e., the actual bandpass filter requirement such transition band (f1, f2) cutoff frequencies, passband ripples, phase linearity, etc... From there you will be able to come to a set of poles/zeros and the filter characteristic (such as...
Agreed that both Design of Analog Filters By-Rolf Schaumann and Mac E.Van Valkenburg and Deliyannis's books are best for undergraduate study if you need/must know the fundamental on how derive the poles/zeros of the filter transfer functions and then use them to derive the actual circuit...
Re: anyone could help ??the osc4 outputs is z in xilinix 2,3
Are u saying you don't have any reset signal come into the chip? This is the reset that I am talking about and you need to create a reset pulse on this signal to reset the entire chip so that all states go to default (logic 0/1). The...
Not sure this one is the best but it's fairly good: 'Practical Analog and Digital Filter Design', Les Thede 2004, published by Artech House, Inc. Give it a try.
Cheers,
-s
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
