Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
expedition +schematic
Thanks for the reply... I will try it and let you know the things.
Added after 48 minutes:
Do you have any .sbk file(schematic file) used with the buses? If so, please upload me. I need it for reference.
design capture bus naming
How to use the bus connection.
When I run the package for the design which had buses to interconnecting the set of nets. It show the error like “Wire ripped from bus is not a valid bus member” for each net.
Please help me to resolve this problem.
expedition tuning
Is there any option to set the value of chamfer length in the tuning option? (In expedition I had checked that the length of chamfer traces was 1x of trace width. So somewhere we can set the value in it).
For example, in allegro the miter option is used to set the length for...
Drill Table in @ltium
In the older altium versions, there is no option to view the drill table in the PCB itself. Also if you enable the option “Tool - preferences - PCB Editor - Display - Convert Special Strings” you can’t able to view it.
But in the Altium Winter 09, there is an option to...
@ltium Designer 6 , Build.6.6.7903
Your are talking about the box comes along with cursor which having the information of x,y,comp. ID & net., ect...
If so, Please try this....
Press shift + H.... it will get off.
pcb design
Hi...
First enable the electrical grid. This is used to find the centre snap point of the pad. Then use the keys P & T. (i.e: the P denoted the place mode and the T denoted the trace). Pick the pad centre and start to route. Plz take care that the design rule is set correctly and...
Termination Technique
Basically the terminations are used to avoid the reflection of signals. As per the maximum power transfer theorem, the maximum power will be transfer when the impedance of the both source and destinations (load) are equal. In the case of PCB, the terminations are used to...
Hi Sankar,
If you rename the .sbk file, It won’t link with current .prj. So if you really need to rename it then you can create the new .prj file and add that .sbk file in that new .prj file.
In Design capture:
Project - New - Give the .prj name and path - Give the library...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
