Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
i know how to setthe ground plane in IE3d but i m getting difficulty in giving V shape. i dont know how to bend the ground plane to make it as V shaped as shown in paper.
can you please make me understand step by step procedure.
i will be very thankful to you.
regards sameer
hello i want to know that how can i make V shape ground plane using IE3D. please somebody tell me step by step. i m working on some paper i attached it also so i want to make the V shaped ground like in the paper
regards
sameer
i want to know the phd positions in antenna in european countries.i have done post graduation in telecommunication engineering and my final year project was HIgh gain microstrip antenna. now i want to pursue PHD in antenna field from europe so can anyone tell me from where i can find phd...
hello, i m sameer
i am learning cst and i have cst 2010 so can anybody send me tutorial for cst 2010 by which i can learn cst by reading it.
i will be very thankful to you
regards
sameer
hello
i m sameer.actually i want to design a microstrip antenna using FR4 and thickness 1.588.but my requirement is both the efficiency should be more than 80%, gain and directivity should be more than 6 dbi.i have designed normal planer antenna but i m not getting my requirement.so plz somebody...
hello all
i want to ask that can i edit feed point once it is set in patch antenna using ie3d
actually i m feeding coaxial feed to get good return loss so i always edit so i always have to design new patch but i want to know that can edit feed point.
plz help me in this
regards sameer
hello
thanx for your reply
i tell you what i have done in my work.
actually, i took the dimension of the patch from one another paper and work on it.i showed that 1st i took the single patch and then put the another patch of the same dimension(IDMA) and between 2 patch air gap is present. as i...
hello thnx for reply
u know i m working to enhance the gain and uptill i have designed to microstrip antenna and i got one conclusion that for having a good gain ground plain plays the imp role. i m saying this bcoz when i was increasing the ground plane size the gain was also increase. but...
hello
this is sameer again
i want to ask about the ground plane dimension. the length of patch is 32.85 and the width of 49.27 so what shud be the dimension of the ground plane.
regards
sameer
Hello i m sameer
as i m new to world of microstrip antenna so these days i m designing a microstrip antenna using Ie3d. and i have designed a microstrip antenna.
It is basically a stacked patch antenna.
and the air gap is used between the antennas.as i m increasing the airgap the bandwidth and...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
