Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Re: Need career advice..!
hi, since you have a variety of experience, I would suggest that you explore each different areas and see where your strenghts are.
You could try to choose a career path, where you can apply your strenghts.
Other way round, is to study and explore more on the areas of...
I would suggest, you can use Simulink in Matlab first, as it seems that you are not well versed in Matlab programming, specifically in Matlab DSP toolbox.
Re: Help Required: My job in crises
first of all-why your job is in crisis? not understand..
regarding the technical feedback, if you are strong in theory, practical implementation should not be a problem.
hi, if we have different brand and model laptops for installation of OS, definitely we need the drivers for the particular laptop. Any suggestion how we get the drivers for various laptops, including old models?
even after pull pin 13 to low,you find that the LEDs are not working you may further see if your bread-board is working properly (continuity test). Sometimes, the contacts will not be proper.
As a next level, think of using transistor driver circuit for the LEDs also.
further to add. Adjust the sweep of the scope to suit to your requirement. You can use a roll mode also, usually seen with HP oscilloscopes. You should be able to see the reset happen.
you can try to read some material on ADC (Analog to Digital Conversion). Bear in mind that TTL, CMOS all have their own digital level standards. You must see what type of hardware you are using here.
Re: Electrical hobby circuits-projects for "begginers&a
hi thanking,
will you let know what etchant you used for make PCB? coz in the link, I see the author has put a ? mark as well.
about the copper coated PCB: is the variety that we get from electronic shops suitable for this / or we need...
are you talking of analog data values? If yes, you must segregate them to digital logic. after that do a truth table logic and proceed to program. if your data is static, there would be no complication. if it is going to be dynamic, your software should be structured accordingly. hope this helps.
for ti interview
You must focus on DSP/Basic Digital Electronics/various protocols liske TCP/IP. You must also be able to explain basic electronics. Definitely they would expect your programming skills good also. Let us know if you get through.
I am looking for learning electronic testing of PCBs after assembly. In short how to develop a small tester. Please send any web links or ebooks that could help.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
