Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Hi
Can anyone help me to design a monopole antenna with coaxial bend in HFSS.?
I need One clarification can we design a monopole antenna with rectangle lumped port feed? If yes please explain
Dear all,
I am a beginner in this field HFSS. I would like to design a four monopole antenna at the 4 edges of a square plane with an angle 45degree or 135deg bent from the plane in HFSS.Can anybody help me to come out of this problem.please suggest me if any study materials are available for...
Can anyone tell me how to measure the HPBW in HFSS software?? Should i measure using radiation pattern or any other option is there??kindly explain in detail
Hai everyone
I am designing a Dipole antenna with four reflectors which are placed at 90deg each in HFSS. I maintained a lambda/4 distance between the ground and the dipole.My problem is the reflector should reflect only when the switch is ON but in my case it is reflecting...
Hai everyone can anyone tell me how and where we can get the mathematical equations for the antenna design.We will design a different types of antenna can we get the mathematical support for everything like length width distance between the reflector plates and the antenna for dipole the gap...
Can you tell me what values you have given for dx dy and dz for this around axis option.Here also we should give values na??
- - - Updated - - -
If i simply go for that option it is coming like this.
- - - Updated - - -
hai nomigoraya thank you so much i got that one...Thank you for your...
Thank you:) can you tell me why the position changed from 70 to 1 on what basis you have made that??
- - - Updated - - -
for square shape i am asking can you set the plates adjacently and send an image it will be helpful for me. plz
- - - Updated - - -
Command DuplicateMirror
"Coordinate...
My problem is i am not getting how to give the position values.
After using that duplicate option 1st we should select base position right? i have chosen that as the FSR end point position later we have to give the values for dx dy and dz right for that what values i should give??
i am giving...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.