Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
questions about a simulink for Li-ion battery model
Hello
I study a paper about Li-ion battery model simulation
the proposed model for state of charge is like this:
and the description of it is:
now I have several questions, 1-what is 100 factor in Eq. 1 ? 2-why use block of power 2 and...
Re: electrical circuit model for Li-ion battery
excuse me my english isnt well
yes I should study the nonlinear charge/discharge
and effect of temprature on it
Re: electrical circuit model for Li-ion battery
I want to design a complete model (with respect to state of charge, temprature and ....) that be like to real Li-ion battery
Hi
I have derived the input admittance of the below circuit in the form of Y1(s)=A(s)/B(s) with replacing the transistors model.
then I add two resistors and one capacitor to the above circuit as below:
now I want to derive the Y2(s), Is it possible to rewrite Y2(s) (for new circuit) based on...
hi
I want to increase the output resistance of common source amplifier, I see some techniques like cascoding or gain boosting
Is there any other techniques ?
Hi dear erikl
the paper said about the gain (A) :
and it seems that the gain is not too high (maybe was low beacuse is less than 2.5)
I try to do your advices, and then show the results
I dont know what is it for, but it is the proposed technique (simulation setup) for measure the input impedance of a circuit by the ADS simulator, and should be placed a 50ohm term at the node that we want to measure input impedance
Yes, I try to design the circuit for a gain little more than 1...
Hi
thanks for your advices, I try to use them and I hope leads to desired results,
some notes:
1-I dont want to simulate whole amp and just I want to simulate and show the negative conductance of red box, and then use it for other circuits.
2-you are right, I should correct my schematic for...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
