Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Hello all,
I am trying to excite a SRR using loop antenna much like inductive coupling on HFSS. However, nothing seems to be working, I am wondering if anyone could help me out in terms of the SRR excitation. Did I misunderstand something about SRR? or Did I miss something on the setup? Thank...
Hello Adnan, I used two ports because I found an example online that was doing it. However, I was not sure as it didn't know show me any result of the simulation. I could change it to one port... The only other thing I have simulated were patch and loop antenna so I don't know much about setting...
Hello all,
I am trying to simulate IDC on HFSS but it just stuck at calculating the matrix step, I am wondering if anyone could help me out on that. I have attached the HFSS file on here. Thanks.
Hello,
I am trying to simulate a simple loop antenna but I am not sure why my the result (current density) does not seem right at all. I am wondering if anyone could help me out and point out where did I set it up wrong.
In addition, I am wondering if anyone could explain me how I should...
Does that mean I would have to have two ground plane or is one enough by connecting to both port? (The rectangle is the ground?)
What do you mean in between? So the ground encapsulates the air and the antenna?
And regrading on my port impedance, if I have 1 ohm resistance and say 1uH for the...
Hello,
I am trying to simulate a simply loop antenna at 2.4GHz. I am not what to do with the lumped ports impedance, and where should I assign the ground? I couldn't any tutorial about them. Thanks.
Hello all, I am new to antenna design... I am wondering if anyone could explain about the port creation in a microstrip patch antenna? What exactly is port? What does the port mean in a physical sense, are they suppose to be the same dimension as suggested by the design rule? if that the case...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
