Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
multicore fpga spartan
Hi,
I am having some trouble with the Xilinx implementation. The thing is that I have two different projects that fits directly into the same FPGA sharing the clock. One of them can run up to 150 MHz and the other one up to 70 MHz.
The problem is if I constraint the...
xilinx xps 8.2 libportability.dll
Yes I have 9.1i for both ISE and EDK and I am starting to think it has to be about Windows Vista or abuot my machine being 64 bits
There is no /bin/nt directory but /bin/nt64 and if I just copy the dlls from ISE to EDK it just keep saying missing DLL...
libportability.dll is missing
I have the same problem but I dont understand the part of "5.Change the any Path to "%Xilinx%\bin\nt; %Xilinx%\bin\nt" and don't forget semi colon in the middle of path name. "
Can you explain it a bit more please?
verilog mouse
If you have your code wrote and simulated and in the real enviorement it didnt work your problem will be probably you didnt debounced the clock line.
It happened to me >_<
Re: Design phone control automations and security system By
If your project is complex.... i would recomend the 18f452//18f458, he can be programed in C18 and if you want to program in assembler, the intruction set is more powerfull
operating frequency of 8051 with crystal of 12mhz
I am using PIC 18f458 for a little proyect with a 20 mhz crystal without any external "special" circuit.
If you see the datasheet You only can reach 40 mhz by using a 10 mhz crystal and activating the 4x internal PLL
The only external...
qpsk in matlab
You can use dmod(y,Fc,Fd,Fs, ... for modulate and ddemod(y,Fc,Fd, ... for demodulate. I dont have matlab instaled onto this comp so. You will need to use the help to see the parameters.
Thanks for both replies ;)
I understand this now.
I only use DIP's with big pads so i think i will have no problem with the missalignament. Anyway i asked the manufacturer if i MUST change the values or if they are fine.
Thanks again
Hello, i am a student from Spain who is finishing his final studies proyect and this is my first PCB outside the university.
I'm going to order my pcb soon, but i have 1 problem.
I will use www.pcb-pool.com to get a prototype board with SM. In their technical page i can find this
Soldermask...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.