Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
I think it is better that you use an inducer in range of milli or micro in parallel with two caps. one of them in range of micro and the other in range of nano.
this is to decrease the low and high frequency noises.
state machine asynchronous output forum
Very good book in asyncronous design is:
Digital Logic Circuit Analysis & Design by P.Nelson, H.Nagel ,D.Cerroll ,J.Irwin
Resistor Colour Coding
the 4 lines are 5 percent resistors
and 5 lines are 1 and less persentage
nice program is resistor color coder( Resistor CC) from schematica
phico lcd
generally standard lcd has 16 pins
pin1->GND pin2->VCC pin3->contrast(usually with potentiometer ) pin4->RS (RS=0 command reg RS=1 data reg) pin5->R/W(read write) pin6->Enable pin7-14 -> Data0-7 pin15 & 16 for backlight in some models
Because the nonlinearity of transistors you can see any harmonic of input in the response of single transistor amplifier but in the differential amplifier you see only odd harmonics and this mean increase in S/N ratio
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
