Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Hi
I am trying to build a power inverter Which is of good quality like commercial inverters. Can you help with some information where to start and Circuits.
Jammula.
Re: HMS30C7202
Hi Ramack!
We are facing a strange problem, with Hms30c7202, Can you give your mail ID I will saned complete details of it. If you can spend some time on MSN we can discusses abot Hnx7202 and linux projects.
thanks in advance
Kiran Jmmula.
Re: HMS30C7202
MMC it is not working, even we are not able to get SPI signals on the BUS.
We are using SPI based on GPIOs. Can u give your project details.
8051 core doesn't support MMU. So you have to go for uClinux which very difficult for controller like 8051.
Linux requires 32 bit core and minmum of 4 MB of flash and 8MB of SDRAM.
There are many controllers which support linux from ATMEL.
at91sam9xxxxx series controllers support Linux.
Hynix...
We are working with ARM SOC from hynix. we need to develop test tool on PC to test Boards in production usig Boundary Scan. The ARM Chip we use supports JTAG and Boundary Scan. I am very much new to this. Can some one help me to develop test tool either in Linux or VC++...
Thanks in advance
HI,
I am very much intrested in learning PCB design using PADs/EAGLE. I am from hyderabad India. Can any one tell me the best place for training in PCB design.
We have embedded Linux device which has ethernet interface. We dondt have browser. We need to configure Proxy setting using linux command Line.
Can any one help in this regard.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
