Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Hello, i want to know how to connect the DAC0800?
Is that the Vr+ and v+is connected to +10V, Vr- and V- is connected to -10V? How to connect the COMP?
What is the different between pin 2(~Iout) and pin 4(Iout)?Any extra connection for Iout?
Thank you.
Re: Connection for LM386
I wanna connect it after the DAC 0800 and before the LMH6321. How should i connect it?
Is there any difference between this two case of connections as below for LM386?
a. pin2(inverting input) is ground
b. pin2(inverting input) is connected to pin5(output)
I just checked the price for Pickit2 from Microchip, and this is much more expensive compared to USB ICSP PIC Programmer V2010. Thanks for your information.
By the way, what is the different between Pickit2 and Pickit3?
---------- Post added at 16:26 ---------- Previous post was at 16:25...
Hey, is "USB ICSP PIC Programmer V2010" can be used to download program to PIC 16F877A?
I mean this "http://www.cytron.com.my/viewProduct.php?pcode=UIC00B&name=USB%20ICSP%20PIC%20Programmer%20V2010".
What is the cons?
May i know what is the software used to program the ATmega 32-16pi Microcontroller?
Besides that, what is the advantage of using ATmega 32-16pi instead of PIC 16F877A?
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.