Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Thanks for you advice :)
I would like to use synchronous rectification as you say, but there is dead region when diode should conduct current.
---------- Post added at 12:44 ---------- Previous post was at 12:20 ----------
What you say is what i worry about, the current though the diode...
Now i have a design of 5V input buck DC-DC, it demand integrate rectify diode in the chip, it will use 0.5um double-well CMOS process. In order to minimize the layout, i would like to use the parasitic n+/pwell diode of nmos(power switch) as the rectify diode, but i'm worried that it will cause...
Thanks for always concern sbout my topic. Now considering the complexity of upd16835, i have tend to other chips. Read the pdf you offered, it is good, but still beyond my need.
Re: some question about step motor diver and the chip UPD168
it is a good choice to use L293 along with LM339 to built a step motor driver with feed back circuit, i think. But i think it is difficult for L293 to realize microstep control which UPD16835 can do.
long for your advice. ^_^
First, thanks for advices. ULC2803 is a good choice to built H-bridge to drive step motor, but i concern more about the control circuit of H-bridge. Such as PWM control, feedback of current sensing, and so on. These tecnologies is applied in UPD16835, but i don't know how it fuction. i have read...
Is there some guy here done sth about step motor driver, i have confused by the use of chip UPD16835 of NEC. Since it has use feedback circuit(Rs and comparator) to fuction PWM, then what is the fuction of chopper in the chip.
Hope somebody to give me some advice, thanks for advance.
circuit ac motor speed
Is there some guy here done sth about step motor driver, i have confused by the use of chip UPD16835 of NEC. Since it has use feedback circuit to fuction PWM, then what is the fuction of chipper in the chip.
hi,all
where can i find Specification of tuner for DVB-C standard,
such as min RFin, max RFin, noisefigure, and so on
Could anybody help me,
Thanks in advance!
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.