Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Re: BPSK BER in rayleigh IN MATLAB : why noise and channel are the same in matlab.
Hi mazdaspring,
I am also new to the fading channel.
Share my point of view with you,
if y = A*x + n,
where
y is the received signal; x is the transmitted signal;
n is complex AWGN with Re[n]=Im[n]=N(0,1);
A...
Hi pulsedia,
The MAP(Bayes) receiver is already implemented from your code. You may see the following criterion.
1): MAP receiver: p(s|y) = p(y|s)p(s) / p(y).
y = s+n.
Where s is i.i.d signal, n is i.i.d. and AWGN, and y is the received signal...
1): I am not sure about it, are you asking how to use the calculator's error function ?
2): how about using matlab to solve erfc (Error function) or to approximate the Error function by Taylor series, or iteration method and etc. within the allowable error range?
For the definition of error...
Hi David83,
Indeed the transmitted is also a R.V. and may not forced to be Gaussian. The received signal can be view as summation of two R.V. But when we want to analyze the noise signal from the received signal, we need to know what type of the transmitted signal is, i.e. BPSK or FSK modulated...
Hi Pals,
Why conventional analog I/Q demodulation is still so popular? (Need two ADC)
Applying digital I/Q demodulation can save one ADC.
Is this not a strong reason to adopt to digital I/Q demodulation?
Hope someone can help me to solve the above questions.
Thank you.
Hi David83,
For dealing with additive for AGWN, there are some experiments that you can check.
For example, if X1 is Gaussian R.V. and X2 is also Gaussian R.V., you can derive the summation of two R.V. (Y = X1+X2) is also a Gaussian R.V.
Based on this concept, you may record the noisy signal and...
Hi Pal,
The following question about single-sideband signal confuse me for a while.
The attached files are my mathematical model.
Please help me to solve my questions and fell free to correct my analysis.
Q1, why the physical output spectrum measured by the spectrum analyzer is always...
Hi everyone,
When I read the 4th edition of digital communication by Proakis,
I can't figure out "a linear representation for CPM signal with (4.3-73)".
I am so confused to math technique of 4.3-73. (How to derive the equation?)
Hope someone can help me.
Thank very much.
Re: about Gated clock
Hi, packet and hash_delay,
I am also confused about why not use DFF for gated clock instead of D-LATCH.
Even I knew clock_en signal need to be re-sync. at the negative edge of clock.
I still wonder to know what is the advantage of using D-LATCH for gated clock.
Below is...
Hi~Pals
I have a trouble about the math question.
Please see the attached picture.
Hope everybody can give me some suggestions.
Thank you.
Best regards.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.