Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
how to reduce the size of microstrip balun,when it works at 2-6G ,but i just have 25mm ?i have try with the klopfstein taper but its result of s11 seems not good enough. do you have any good ideals?help
i need to design a Coaxial impedance transformation which as a part of a complex antenna ,but i am not sure about the feed in feko. i use the waveports,then meshed it has wrong in the port.could anybody can give me some suggestion.plz
hi Azulykit
i have read the paper ,and do a simuation like its siad ,the result is good but i cannot make it continuous .could you give some example?
- - - Updated - - -
hi biff44
i cannot understand clearly .but you said seems professional .i not good at this part ,could you give me more...
hi aniakhan
do you have any model of klopenstein balun and exponential taper balun .thoes days i have made a exponential taper balun .the result of the s11 is good ,but the s21 seems not good enough .could you give me some advice.
hi aniakhan
could you point some key problem of the design tapered balun ,i am not clear of the part ,but someday later i have a chance to ask the expert ,i would not like to lost face !!plz
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
