Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Hi, adding more info..
There is no signal integrity issues, no supply issues, and other series of chips are working fine, \
The identified issues is in fast read, other chip allow us to pause transaction for a while and can continue. and SPI suppose to work like that. But W25Q64JW causing...
Hi,
I and using Dediprog to read certain register from W25Q64JW by fast read command. It is always reading second byte after a pause 0xFF from SPI, But actual data is 00. and this pause introduces by Dediprog SF100 due to some buffering issue.
If someone have any clue please help
Thanks
Hello all,
I am in a search of high voltage DC Common mode choke, However could not find many with more than 100V DC rated.
I could find varies values and rating for AC CMC,
Please anyone tell me if I can use it for my DC
Hi,
Please find Maxims Application note,
It will do what you are looking for,
https://www.maximintegrated.com/app-notes/index.mvp/id/2158
There are many similar products available for high side drive with shortcircuit protection, LT also have some chips
PROFET™: Smart High Side Switches from...
You can use a small value polyfuse and a TVS,
Also will get some idea from below TI s aplication notes\
https://www.ti.com/lit/an/slla292a/slla292a.pdf
I am currently addressing a 128Mbit flash using 24 address lines, 8 data lines, and 1 chip select line (the processor has 2 chip selects).
What does the external logic look if I want to use a second chip select line to create a high address line? I want to use a 256Mbit flash.
I tried it and...
Hello,
I am strugling with a design of synchronous buck converter using Atmega8 timer1 and IR2110.
I am facing problem withlack of dead time.
Some one please help me how we can introduce dead time in Timer1 fast PWM mode
Hi
I am seein 1.2V to 5volt mobile charger. They havnt used any costly IC. They used one small mosfet and some general component.
Do any one having similar circuit?
Please help me to find one
Thanks
Grittin
Hi,
I want to display current measured in 2 digit. Please suggest me how to do it.
nominal current sensor voltage is 2.5V. and from thr 25mv per Amps.
I want to display this in two digit from 1 to 20amps.I need help only in convertion to digit. I have program to display the digits. I am using...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
