Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
the antenna is an embedded patch antenna.. https://skylab.en.alibaba.com/product/276672054-209705489/gps_module_with_antenna_Skylab_SKM53.html
if you want to buy the antenna then first make sure in which frequency range you will be working in, and you can't buy only the antenna part of this...
what kind of help do you want ? do you want to use it in some application or you want to learn about the MSA ? if you want to learn about it then you can get lots of materials online. if you want to use it in some application, then you should tell what you want to do, only then you can expect...
thank you...i was looking for pole frequency..now since you have told about 3db cut-off frequency, can you tell me how to calculate it ( forButterworth)?
how do i find out the rate of change of output voltage in this circuit? the input is a square wave of 5V, R=5K, C=25uF
circuit: https://obrazki.elektroda.pl/44_1344097071.jpg
please forgive my ignorance, i am still in the beginning stages, but what do you mean by frequency of the ramp? slope of the signal is 1 means the equation of the signal will be " y=t for t>0 ", so doesn't it completely defines the signal? what other parameter do we need here? and i just wanted...
frequency of the ramp?? well the slope of the ramp is 1 and the circuit is 1st order low-pass circuit..1 resistor and 1 cap with a voltage supply.. and RC time constant ? i don't think we really need it here..
- - - Updated - - -
there is an option called user defined signal..but i am not...
if i have a ramp input to a simple first order low pass RC circuit, then what will be the waveforms across R and C ? i am not able to get the ramp input in my simulation software(TINA-student version)..plz help.. thank you..
if i give a square wave input to a lowpass filter(1st order) whose corner frequency is much higher than the input frequency, at the output do i get a square wave or triangular wave(since 1st order lowpass is an integrator)?
if cutoff frequency is 10kHz and if i give an input of 50Hz then i...
in many posts i saw that flip flops are edge sensitive where as latches are level sensitive.but somewhere i read that even flipflops can be made level sensitive. so what is the difference between a level sensitive flipflop and a latch?
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
