Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Recent content by dsPIC24F

  1. D

    PICkit2 remove from USB? - way to shut down the USB port

    PICkit2 remove from USB? If you can, try to run a montherboard diagnostic and see if all USB port hardware is still health.
  2. D

    is HFSS compatible with VISTA?

    hfss vista Cool, that's smart. How did you do the registration under Vista?
  3. D

    Level translation - Supporting 1.2 - 5V

    3.3v to 5v voltage level translation your freq could be too high for low cost chips.
  4. D

    ir sender-receiver circuit

    led receiver circuit There are some packages with both sender and receiver.
  5. D

    Protect the contact of one relay

    Have you put a diode on the control side?
  6. D

    Question on DDR2 laptop memory.

    Agree, 667 basically is the same as 533, but with higher speed. So it should work.
  7. D

    kindly help me in sampling this bandpass signal...

    sampling of bandpass signals Have you tried MTLAB demos? Though people said they are all junk. To me, it worth a try.
  8. D

    Is their any 32GB Pen Drive in Market???

    what you need maybe a external hard driver, which will be huge volume.
  9. D

    Compensation issue in buck DC/DC design

    DCDC design issue the tough part for SMPS is the noise generated by the power supply itself. I use metal shielding, still got some noise leaking. Tough to fight and it is case by case.
  10. D

    CB0703-PCB for "PICkit 2" DIY(Do It Yourself) fans

    pg164120 without low pin count demo What a good couple-show here again. One in red face, just like a mad dog. One in white face, keep pretending to be an expert. Are two of you going to mis-lead us, again? What a show! Are we blind?:(
  11. D

    Questions about using Cadence Allegro

    allegro 15.7 control menu help That's really a lot staff to learn. Is it always so hard to get started?
  12. D

    How to learn skill in cadence enviroment ?

    Does cadence include any tutorial or demo?
  13. D

    How to update output port in two process

    what processor? Can you use interrupt and set the capture sense both up jump and down jump?
  14. D

    What r the processors made by intel ?

    8098, 8096, 80c196 KA,KB, KC, KM
  15. D

    Fundamentals of Cellular Network Planning and Optimisation

    Not allowed here.
See more

Part and Inventory Search

Back
Top