Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
I have a library and want to copy a component within the same library to make a new component after modificate it.
Please let me know how to do this.
Thanks.
If the dimmer uses a pot, another possibility is to use a digital pot controlled by the micro, but you need to isolate the microcontroller from AC levels.
I have two board designs, and want to insert or merge into another one.
The board I want to insert is a small modular piece, and I want to insert it on a bigger board.
Is there an easy way to do this ?
If you want to drop from 5 to 3.6 Volts, just add two Si diodes in series, with the correct diode polarity.
Each Si diode will drop around 0.7 volts
Don't use resistors since the phone is a dynamic load (Current consumption changing by the time).
Regards.
One way is:
- Select the Draw Lines tool
- Select the Dimension layer
- Select widht of the line to 0
- Start the rectangle from origin 0,0
You are done
Re: Lcd screen
Timing is a key, some procedures will mention to wait for 15 mSec, others will say 40 mSec.
In my case I needed to find the correct time for my system.
There are two initialization types, hardware and software, and is tricky what to choose, if you want to go safe choose the...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
