Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
understanding iq signals
Hi, all
Currently I have one question regarding of digital I/Q and Analog I/Q signal. As we know, the analog I/Q traces connect from baseband IC to transceiver IC for providing modulation signals. And the layout should be keeping a complete ground area for I/Q trace...
Hi, all
I know CST is able to simulate base on time and frequency domain. Can anybody tell me how to set to see the time-domain response, for example using the simple 2-port microstrip line.
Hi, all
Currently I have a 464MHz SAW filter need to implement my design board, but I found the impedance matching is very difficult because its high impedance of more than 800 Ohm. So that I want to use simulation tool to do the preliminary circuit matching. PS: I got the S-parameters file...
I got a power amplifier sample, but I want to measure the PA characteristics
What test items shall I need to note that ? And how shall I measure these items?
thanks,
Hi, all
Recently I have a project that use two SAW filters in RF board, but I want to know impedance matching of these filters. How do I verify that ?
Thanks,
Hi, everybody
We know an antenna built-in a plastic housing, the resonant frequency will be shifted to lower band. For building simulation model, we shall create a housing mode into the antenna model. My question is, if we take a housing, but we don't know the dielectric constant of this...
Could you tell us which antenna configuration that you design, the antenna size of 40*20mm2 is so big that can't meet wireless product space.
As my experiences, using quarter wavelength antenna, such as PIFA or monopole antenna, the bandwidth is of more than 150MHz with fine tuning.
Hi, everybody,
I found smith chart file has S11 amplitude/phase on CST software, if I want to compare with simulated/measured smith chart plotted on the same diagram, how shall I do?
Thanks in advance.
Hi, everybody
Now I am studying printed antenna for WiMAX applications, could you please provide related design imforation /specification on radiation patterns requirements to me ?
Thanks in advance.
RFID antenna problem
Now I have a antenna problem on RFID antenna; If I want to design 4 antennas printed on a 85*55 mm2 PCB board. Two antennas are operated at 915MHz, the other are design at 2.4GHz. How shall I do this design?
Shall I use loop antenna or PIFA ??
someone can give me some...
Re: HFSS AIR BOX PROBLEM
In typically, we set the air box size to be near quarter-wavelength, then use the funcation, PML, optimize the better box size. But remember, the solution frequency shall be near the wanted frequency.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.