Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Hello again
i could implement my mixer in AWR but i have problems tuning it actually the equation was for a transistor and had to design the mixer by a BJT i did it but now i dont know what are the appropriate values for LO and RF. i taught the LO frequency must be much higher than RF signal...
hello
i have the input voltage versus output current equation as i(t)=I0*e^avi(t) in an element and want to use this element in a circuit to have a mixer but i dont know from where should i start
can anybody help me
one thing i know is that this elements acts like a diode but there is a...
Hello everybody
will be thankfull if anybody can help me soon
i need to design an amplifier by AWR microwave office by a transistor with following parameters
vce=10 volt, ic=2mA, f=400MHz
yie=7+j11.5
yre=0-j0.9
yfe=37-j37
yoe=0.2+j5
this amplifier must have the stability factor k=2
and also need...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.