Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
@KlausST
@FvM
pin 5 is hpwm 12f683 and 1khz
For example %100 duty mosfets are heating.Why?What is the problem ırlz44?irlz44 are logic levels mosfet
I want not to use heatsink
Hello guys,
I am driving 15a lamp via MOSFETs without Heat sink .
How I can protect MOSFETs from burning??
is necessary pull down resistor?
Mosfets are very hot.Also ı used logic level ırlz44 mosfet.
No I have not heatsink
And is the collector resistor 1k enough?
İs there a way without circuit?If ı use IR2103, am ı need heatshink?Because ı think ıf I use IR2103
I am going to use this circuit in my car for car's lamps.
And I have not access to the - side. I am use only +side of lamps
So I used p channel IRF9540.but mosfet is burning.:(
I am very sorry.I need to take circuit
I want to dimmer a lamp (40 or 50 watt) with ne555 with p channel
But p channel mosfet is burning.So I am going to try with IR2103 and IRFZ44.. IRFZ44 like p channel with IR2103
Do you think the circuit is true?Please help me.
And I have only 12v adaptor.
**broken link removed**
I want to do dimmer(10amper bulb) with ne 555.
But IRF9540 p channel mosfet is not enough for 10amper and the mosfet is warming
I want do use another p channel mosfet.Which do you think can I use p channel mosfet mosfet?
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.