Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
HI all,
I need a genetic Algorithm Library in VHDL/verilog to use in my personal work.
If any one knows the source of Genetic Algorithm library in VHDL/Verilog. then pls share the link.
Thank you.
hi all,
I have written code for ibutton access control system using LPC2148. Individually all worked fine.
when integrated, it behaves different. I have tried several changes in that I dont know what thing I am missing.
as per code flow : it should display choice of Registration phase and user...
Hi,
I want to implement HDL code for USRT (Universal Synchronous Receive transmit).....
Note that it is not UART. I need USRT, synchronous communication.
I have gone through some material.
As per those, in sync communication there is block of data to be transferred ...the protocol is as...
Deal all,
I m getting high timing score for two clk nets in Xilinx ISE, how to minimize timing score or make it zero.
Can any one explain step by step.
Thanks
It looks like Board to wire connector....you can go through this category of connectors in SAMTECH, Molex and Tyco website...Hopefully you will get this connector...
You can verify other details like connector dimensions...once you found a closed match..
Basically you want to drive LED with AC source... For this you can use Capacitor voltage divider instead of voltage divider. there will very less dissipation in capacitor voltage divider.
One important thing is...18V across single LED is too much...Thats why it is flickering and died in 3-4...
Instead of CPLD you can go for low cast FPGA like SPARTAN 3. The cost is almost same...but you will get more logic elements in FPGA...Easily you can port I2C code and your algorithm.
Best of Luck
Which FPGA kit you are having...and what kind of IP licences you are having.? This will decide the vast learning area through any project...Kindly Give these detials..
I will suggest you some projects on that basis..
for Current upto 5 Amp you have to use shunt resistor. For nontouching current resistor you can use Hall effect current sensor....
We will discuss more about block diagram in future....
Best of luck
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
