Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Hi
I have bought this antenna
If your design will be at open air you should try passive antenna otherwise active.
I'm workin on Sim908 too , take a look
regards!
Yes , parallel capacitors but closely to VCC pins of mcu. This is to avoid or reduce perturbance. 1000uF for low frecuency ,it makes the VCC source smooth but it can't smooth high frecuencies that's why you add 0.1uF and 0.01uF .
There is no problem with Vref.
LP filter means Low Pass filter ...
My circuit has been working for a while.
Just change resistor values for zerocross LED,triac resistors/moc3020(400v peak ) There are calculated for 127VAC.
regards!
Try to keep away the relay from the mcu lines.
Add some bypass capacitors to mcu psu,let me explain ,connect the 0.1uF and 0.01uF capacitors as close you can to VCC pins of mcu.
This should help.
Regards!
The Bypass capacitors are a rule.
THen Check LP filters.
As ligo says.
Divide your data in 3 parts then use the USART todo send 8 bit packets(data low, mid and high).
That`s the best way or you could use software USART and send the complete 24bit data at once.
Hi
check microchip page Microchip Technology Inc. | Motor Control and Drive - Overview
Try to use a pic18F wich has better hardware and performance than a pic16 but if you need more math pic24 could be the best, there is a long bridge between pic16/18 to pic24/dspic.
regards!
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.