Yield sensitivity measurement in AWR Microwave office is not giving any results

[avins_1234]

Hi

In the yield analysis example, I am trying to plot YSENS measurement for capacitor and dielectric, but nothing comes up irrespective of whether I select Histogram or rectangular to be the type of the graph. The simulation runs, but nothing appears on the graph.
How do I plot these component sensitivity histograms ?

The project is a simple low pass filter designed in AWR MWO.

cheers

 

[Manuel Maritescu]

Hy,

i have looked at youre example and i must say that for this analyze you must put an Yield Analyze when you simulate.So click the tab Simulate/Yield analysis and put for example 100 Iterations.Than you will see on a Histogram graph the meassurements.

Good luck and if you don't achieve what i explain i will sent you the example.