2ndhandscope
Newbie level 4
Hello,
Upon testing my new 475 Tek scope, I noticed that XY mode figures are displayed off to the right side instead of the center. When adjusting X signal vertical position, I was able to move the figure back to the center but that would mean the X signal is off center when viewed in normal modes. I have both vertical and horizontal set on the same scale, same coupling, each signal when viewed individually in normal sweep are centered vertically.
I dont have any ideas why this might be the case. Can you share your suggestions ?
Thanks!
Upon testing my new 475 Tek scope, I noticed that XY mode figures are displayed off to the right side instead of the center. When adjusting X signal vertical position, I was able to move the figure back to the center but that would mean the X signal is off center when viewed in normal modes. I have both vertical and horizontal set on the same scale, same coupling, each signal when viewed individually in normal sweep are centered vertically.
I dont have any ideas why this might be the case. Can you share your suggestions ?
Thanks!