xol
Newbie level 2
Dear all,
I'm trying to configure the AXI Chip2Chip core from Xilinx to use a GTP as PHY interface.
Apparently, it requires the use of an Aurora PHY. In the Zynq device I'm using, I have only 4 GTPs available but only one routed the Kintex FPGA I want to interface with.
The only Aurora core available for my Zynq device is the Aurora 8B/10B and configuring the chip2chip to use that PHY requires that I use 2 Aurora Lanes, consuming 2 GTPs and, as I said, I only have available 1...
Does anyone know about a possible solution to interface the chip2chip core with one GTP only?
Thanks and best regards
I'm trying to configure the AXI Chip2Chip core from Xilinx to use a GTP as PHY interface.
Apparently, it requires the use of an Aurora PHY. In the Zynq device I'm using, I have only 4 GTPs available but only one routed the Kintex FPGA I want to interface with.
The only Aurora core available for my Zynq device is the Aurora 8B/10B and configuring the chip2chip to use that PHY requires that I use 2 Aurora Lanes, consuming 2 GTPs and, as I said, I only have available 1...
Does anyone know about a possible solution to interface the chip2chip core with one GTP only?
Thanks and best regards