Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Wishbone2AXI bridge development

Status
Not open for further replies.

dpaul

Advanced Member level 5
Advanced Member level 5
Joined
Jan 16, 2008
Messages
1,859
Helped
317
Reputation
635
Reaction score
352
Trophy points
1,373
Location
Germany
Visit site
Activity points
13,466
Hi,

I have a requirement to build a Wishbone2AXI bridge. Want to save some time by not re-inventing the wheel, so was wondering if any freely available RTL exists.

Have already checked OpenCores and there exists an incomplete project "Wishbone protocol to axi4 protocol" with only the specs checked-in. So was wondering if anyone has knowledge about any other sources.

If there's nothing I'll design the bridge from scratch.

Thanks,
dpaul
 

This is the I know of but it hasn't been improved or updated since 2011.

I haven't personally checked it out, other than glance at the code, so I have no idea if a simulation could be run or if it's a good starting point.
 
  • Like
Reactions: dpaul

    dpaul

    Points: 2
    Helpful Answer Positive Rating
Thanks ads-ee!
I will take a look into into it and decide if it is a good starting point or needs radical changes (as per my project boundary conditions).
 

Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top