Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Wideband baseband spectrum measurement

Status
Not open for further replies.

erictmt

Newbie level 5
Joined
Sep 23, 2003
Messages
10
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Activity points
112
I'm designing a direct conversion receiver that processes the baseband signal with about 300MHz bandwidth. However, I'm wondering how to measure this signal? Is it possible to have an active probe that connects to an SMA connector such that I don't need to drive a 50Ohm load? Thank you for the advices...
 

Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Top