Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Why transistor NE3210S01 still oscillates when gate is biased almost -3v?

Status
Not open for further replies.

Terminator3

Advanced Member level 3
Advanced Member level 3
Joined
Feb 25, 2012
Messages
802
Helped
71
Reputation
142
Reaction score
63
Trophy points
1,308
Visit site
Activity points
9,027
I can't understand why is this?
- both source pins directly grounded through two holes to back side of PCB, so there are no any additional inductance
- gate is biased -2.5v
 

Make sure you have a coil (filter) on the DC bias sources. These hidden signals could perturb you device.
 

Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top