Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronic Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Why do I get ID error while burning PIC16f628A?

Status
Not open for further replies.

gonewiththewind

Newbie level 4
Joined
Jun 21, 2005
Messages
6
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Activity points
1,320
hi hi!
I'm still a new baby. I'd like to know why ID error on burning PIC16F628a.Pls do me a favour.
 

curgan

Junior Member level 1
Joined
Aug 28, 2004
Messages
17
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Activity points
138
Re: pic16f628a

change chip try again.if it doesn't solve problem it may be problem with programmer and don't forget turn off lvp and try16f628 not 628a one
 

Buriedcode

Full Member level 6
Joined
May 6, 2004
Messages
357
Helped
43
Reputation
86
Reaction score
7
Trophy points
1,298
Location
London
Activity points
8,887
Re: pic16f628a

Hi gonewiththewind,

Please be more specific about your problem. Try to include the following:

What programmer do you use? Is it DIY or a purchased one?
What software to you use to program the micro?
What software to you use to compile?

ALthough micro's can generally be programmed quite easily, there a many things that can go wrong, voltages, bad connections, software problems.etc...

BuriedCode.
 

yousafzai

Full Member level 5
Joined
Jun 1, 2006
Messages
244
Helped
15
Reputation
30
Reaction score
8
Trophy points
1,298
Activity points
2,292
Re: pic16f628a

First read complete documentation of ur programmer and then check the datasheet of ur micro-controller.As a last resort change the microcontroller and see what happens.......
 

Status
Not open for further replies.
Toggle Sidebar

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Top