Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

which part or circuit you know i can feedback voltage to control center

Status
Not open for further replies.

mp8878

Newbie level 1
Newbie level 1
Joined
Mar 6, 2014
Messages
1
Helped
0
Reputation
0
Reaction score
0
Trophy points
1
Visit site
Activity points
6
i want to make a Three-phase rectifier ,i have to feedback voltage of all three phase to the control center,can you name a part or circuit i can use to do that?
 

You could use 3 transformers, which each will give you a fully floating low AC out, so you can connect them to a earthed control circuit. You could use opto isolators with a series resistor and a reverse protection diode, this will be cheaper then the transformer solution BUT will need some sort of gain control to calibrate and balance their outputs. Make sure that the output from either system is clamped with diodes and has a series resistor and has adequate clearance from other components on the PCB (a completely different board would be better). This is to ensure that your monitoring system will never be connected to the three phase in the event of an insulation failure.
Frank
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top