Just powered up my M3 board (LPC1343), running trough the demo code I can find the software interface(registers) for the modules(usb, uart,..) but in the official pdf only a brief description is available.
Where is the full documentation? Or am i missing something?
I was searching for LPC1343, the user manual is under Design support... and not included in the all documentation package, I could have looked better, just another stupid user error )
Thanks again Keith.
Make sure you look at the errata sheet. I don't know NXP's processor but with Microchip some important information is often hidden in there which contradicts the datasheet.