Sunshine_accu
Newbie
The exact procedure is desribed in detail as follows:
1、generate the corresponding simulation module(post translate simulation module or post-PAR simulation model)
2、click simulate post-translate/post PAR model, enter modelsim
The result is that simulation of post-translate has no output(output is always 0); while post-PAR has expected output. Figures are as following screenshots.
post-par sim(expected output)
post-trans sim(NOT expected, output is always 0)
Please, if someone ever is met with the same problem? Expect your timely help ang guidance.
1、generate the corresponding simulation module(post translate simulation module or post-PAR simulation model)
2、click simulate post-translate/post PAR model, enter modelsim
The result is that simulation of post-translate has no output(output is always 0); while post-PAR has expected output. Figures are as following screenshots.
post-par sim(expected output)
post-trans sim(NOT expected, output is always 0)
Please, if someone ever is met with the same problem? Expect your timely help ang guidance.