Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Normally in TC of PTAT voltage is about 2-mV/K, which is same as TC of BJT (if BJT is used to contruct a bandgap circuit), so that these two component can be cancelled through out the intended temperature range.
The question wasn't well asked, the answer is totally wrong.
these are the comments, anyway, I try to contribute whatever i can, but in this case, i just have to tell the authors to not waste time posting nonsense
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
