Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

[51] what is the indication of letter 'S' in AT89S51 & 'C' in AT89C51

Status
Not open for further replies.
V

v.s.n.kumar

Member level 1
Member level 1
Joined
Dec 2, 2013
Messages
38
Helped
0
Reputation
0
Reaction score
0
Trophy points
6
Visit site
Activity points
303
Hi,
can anybody tell what is the indication of 'S' in AT89S51 & 'C' in AT89C51.
 

There are several differences between the AT89S51 and the AT89C51, however the main points are as follows:

AT89S51:

Can be programmed using either In-System Programming (ISP), which utilizes the standard SPI interface, or High Voltage Parallel Programming modes.

Fully Static Operation: 0 Hz to 33 MHz


AT89C51:

Depending on the exact model, can be programmed utilizing a parallel programming mode requiring either high voltage or low voltage.

Fully Static Operation: 0 Hz to 24 MHz


Reference the links to the device datasheets for an exact device comparison and other differences.


BigDog
 

Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top