Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

What is meant by Rx level and what is its practical application?

Status
Not open for further replies.
Re: Rx level

Dear rahul

Rx level means the received power by any receiver from certain transmitter, it is measured by mw or dBm.

The practical application is that it can be used for measuring the received level by mobile station from base station to check the coverage of this site
 

Re: Rx level

Thanx Mr.Ibrahim.

So what are the factors on which Rx level depends???

regards,
Rahul
 

Re: Rx level

Why are posting it twice...? Rahul u have already posted the same in Antenna forum and vfone has already replied to it...didn't you see that reply... before posting it here...? or whatever...
 

Re: Rx level

Dear rahul

The Rx level depends on many factors such as the losses and gains of both the transmitted and received antenna, also it depends on the path loss between the transmitter and receiver which is affected by many factors such as the terrian, the distance between the transmitter and receiver, the frequency used, the height of the transmitted and received antenna, also it depends on the transmitted power value

please if this information is helpful for you, press Helped me button

Best Regards
 
Re: Rx level

Thanx Mr. Ibrahim.

Mr. Ibrahim Plz provide me the mathematical formulae for determining Rx level.

regards,
Rahul
 

Re: Rx level

Dear rahul

The mathematical formula for the RX level is:

Pr=Pt+Gt-Lp+Gr

where: Pr: RX level
Pt: transmitted power
Gt: gain of transmitter antenna
Gr: gain of receiver antenna
Lp: path loss between the transmitter and receiver

Lp has many mathematical formauls due to many propagation models, which differs from each other due to frequency(900 or 180-0 MHz) or area type(dense urban, urban, suburban, rural), no one saves all these formulas of the path loss for different models but onle know which parameters increase or decease the loss
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top