Welcome to EDAboard.com
Welcome to our site! EDAboard.com is an international Electronic Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
What are the main features of an stepper motor?
- Thread starter mkiani
- Start date
- Status
A.Anand Srinivasan
Advanced Member level 5
Re: stepper
the main feature of stepper motor is that it can rotate in steps which are very small angles... which an ordinary motor cant...
the main feature of stepper motor is that it can rotate in steps which are very small angles... which an ordinary motor cant...
hbaocr
Full Member level 4
stepper
hi,Using Step motor you can control smooth because it can be controled to rorate in small angles. But arcoding to my experience the ordinary motor may be stronger than step motor If they are the same RPM (revolutions per minute) .
hi,Using Step motor you can control smooth because it can be controled to rorate in small angles. But arcoding to my experience the ordinary motor may be stronger than step motor If they are the same RPM (revolutions per minute) .
Andrew8611
Member level 1
Re: stepper
the step motor can move to specific angles only varying the amount of voltage given to it during a certain time, it doesn´t move without energy which makes it perfect for small robots or precision designs.
the step motor can move to specific angles only varying the amount of voltage given to it during a certain time, it doesn´t move without energy which makes it perfect for small robots or precision designs.
shiveshdubey
Junior Member level 3
Re: stepper
The main advantage of stepper motors is that they can achieve accurate position control without the requirement for position feedback. In other words, they can run "open-loop", which significantly reduces the cost of a position control system.thus stepper motors are used where predefined steps have to be changes.mkiani said:
- Status
