Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

wat is the lacthup problem?

Status
Not open for further replies.
HI

Can u be elaborate ple in what sence u want to know about latch up problem?
Like in verlilog prog while the time of writting code we infer a latch and because of which we don't get the exact functionality...
 

In CMOS fabrication due to its structure there may be chance for inferring Parasitic Transistors , due to which there will a connection between vcc and vdd. Due to this IC may get damage. this is Latchup effect.

u can get more info from this..
 

Please refer the following page for more details.

**broken link removed**

I have used PTAP & NTAP( Well & Substrate Connection) cells to avoid the Latch-Up violations.
 

There is a low impedence path occured inbetween Vdd and Vss.So because of that huge amount of current flows in the device and causes to destroy the device permanently.The avoide this latchup we use guardrings.

For mor details ple reffer Kang Digital VLSI deisgn.
 

Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top