Any idea in why I am receiving these Warnings? and how to remove them?
An array simulation in momentum is taking almost 5 hours for me.. I was wondering if the time can be reduced by increasing the mesh size? Is it possible to control mesh size in ADS 2016?
What should I change in the settings? I am trying to design a linear array as of now and the S parameters show broken lines and no particular frequency of resonance.
I have eight antenna elements in my X axis and have eight antenna ports to be connected to each of them for this scenario I need eight ports as feeding ports at the end of my feed lines and eight ports on the GND? or a single port be enough to serve my purpose?