Eng.Wad
Member level 2
Hi everyone
I was trying to write the .hex file into pic18f2550 using pickit 2. before clicking on write" , a warning message appeared in the box:
"Warning some configuration words not in hex file
ensure default values above right are acceptable "
my config is
what shall I configure more ?
if anybody had experienced it before, plz share.
Thanks
I was trying to write the .hex file into pic18f2550 using pickit 2. before clicking on write" , a warning message appeared in the box:
"Warning some configuration words not in hex file
ensure default values above right are acceptable "
my config is
Code:
#pragma config OSC = XT // 4MHz Crystal, (XT oscillator)
#pragma config PBADEN = OFF // PORTB<4:0> pins are configured as digital I/O on Reset)
if anybody had experienced it before, plz share.
Thanks