Hi,
For AT89C52 you need a programmer,i mean the hardware.
Try ADuC832 sort of microcontrollers(or search for ISP programmable microcontrollers)..Architecturewise there is no big difference-same 8052 core architecture.You will only need a cable(RS232 serial) and a software(free) to download the program.
Easy and fast..!!!
Thanks for the reply .. u told about ADuC832.. but i dont' have that kind of money or in a position to buy one. I want to build one. I've found some diagram in AT89SXX series which can be easily programmed directly using PC serial/parallel port.
Is their anything like that in the AT89C52 ???
and another question is. Where i can find a good ebook for programming for µC in (C/C++) ??
Thanks for the reply .. u told about ADuC832.. but i dont' have that kind of money or in a position to buy one. I want to build one. I've found some diagram in AT89SXX series which can be easily programmed directly using PC serial/parallel port.
Is their anything like that in the AT89C52 ???
and another question is. Where i can find a good ebook for programming for µC in (C/C++) ??
Hi,
There are a lot of ISP programmable microntrollers from Atmel.
Try browse atmel website.If it is ISP programmable you can use it.
You will see microcontroller with different memory size , no. of pins...etc.
But the core architecture is same..
Just go thru the datasheet..
Re: very new to microcontroller... Need lot of help from Ami
Hi,
Please help me. I brought pickit 2. I build separate connector for program 16F84A. It doesnt work. Computer show "voltage level error"
I didn't use RC for clock.
Amil
Hi Amil,
For pic 16f84A, connect the pickit2 connections in the following way:
Pin 1 to pin 4 of ucontroller
Pin 2 to pin 14 of controller
pin 3 to pin 5 of controller
pin 4 to pin 13 of controller
pin 5 to pin 12 of controller
Oscillator is not required here. You just connect the Pickit 2 with the above mentioned pins of pic16f84 and program with software. It will suffice. Thanks.
Instead of 89C52, you could use 89S52, which is ISP programmable(ISP Programmer is just some 4 wires connected from parallel port of PC to mcu through buffer).
I have published some interfacing tutorials at
**broken link removed**
At the end of the page, I have linked to another page, which describes how to set up your home lab for microcontrollers, with snapshots illustrating KEIL IDE, ISP programmer and link for ISP programmer circuit.
Enjoy learning microcontrollers