Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronic Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

value of chamfer length in the tuning option??

Status
Not open for further replies.

arunrajendhar

Member level 3
Joined
Dec 25, 2008
Messages
63
Helped
1
Reputation
2
Reaction score
1
Trophy points
1,288
Location
India
Activity points
1,630
Is there any option to set the value of chamfer length in the tuning option? (In expedition I had checked that the length of chamfer traces was 1x of trace width. So somewhere we can set the value in it).

For example, in allegro the miter option is used to set the length for 45` deg traces. Please respond if anybody knows this.
 

Status
Not open for further replies.
Toggle Sidebar

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Top