Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Using two UARTs on PIC18F26J13

Status
Not open for further replies.
S

ste2006

Advanced Member level 4
Joined
May 1, 2012
Messages
118
Helped
3
Reputation
6
Reaction score
3
Trophy points
1,298
Activity points
2,226
Hi Guys,

I know this is going to be a simple question but i just cant seem to figure it out,

I am using the PIC18F26J13 and have my program written in C working away happily using UART1

However i now want to access a different module using UART2 but i cant seem to figure out what pins UART2 uses or maybe it uses the same pins??

If it uses the same pins how can i tell one module to not listen and if that is the case what is the point of the two UARTS,

I am using RS232 by the way,

Thanks,
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top