Hi CosaNostra,
Your questions are not quite clear. Are you saying that you are not going to use the I2C engine but intend to interface the I2C slave device using GPIOs?
hi
if you familiar with I2C protocol ,each deviece have a address in I2C BUS. these address may be setted by connecting pin to H or L .
In this protocol ,master deviece make a start signal and send add .Slave deviece that matched with this address send and acknowledge .
finaly master send a Command and wait for another acknowledge.
In end a stop signal send by master for end of comunication.
hi
if you familiar with I2C protocol ,each deviece have a address in I2C BUS. these address may be setted by connecting pin to H or L .
In this protocol ,master deviece make a start signal and send add .Slave deviece that matched with this address send and acknowledge .
finaly master send a Command and wait for another acknowledge.
In end a stop signal send by master for end of comunication.
hi
if you familiar with I2C protocol ,each deviece have a address in I2C BUS. these address may be setted by connecting pin to H or L .
In this protocol ,master deviece make a start signal and send add .Slave deviece that matched with this address send and acknowledge .
finaly master send a Command and wait for another acknowledge.
In end a stop signal send by master for end of comunication.